Cold Storage Room Control Panel

Product Details:

The SZ-FR-2000 is a panel/wall mounted controller dedicated to control fruit ripening process.


Main Features:

• 7 Segment LED display & LCD with backlight to display all parameters and control status
• In the absence of a CO₂ sensor, Unit will work on an ON/OFF logic provided 2 for Damper/Fan operation to vent CO₂.
• Automatic control of Ethylene by operation of a Solenoid valve.
• In the absence of an ethylene sensor, unit will work on an On/Off logic provided for ethylene solenoid valve.
• Real time clock incase of power failure to keep in memory number of hours operated.
• One push button activation for complete operation of ripening process.

Input & Output:

• Relay Output : 8(3)A for Solenoid Valve, Damper/Exhaust Fan, Humidifier & Alarm.
• Sensor Input : Temperature sensor : NTC(0-50° C) CO₂ sensor : 4-20mA, 0-1%. 2 Ethylene sensor : 4-20mA, 0-999ppm.
• Humidity sensor : 4-20mA, 0-100% RH.

 

Product Details:

The controller controls the defrost in the system based on either an electrical heater where the compressor is stopped, or at cycle inversion using warm gas where the compressor keeps on working.

There are safety features which include shutting down the system incase of a fault from a pressure control or similar device.

 

A series of “safety controls” (delay at start-up, minimum disable time, minimum time between activation) protects the compressors from close starts. In case of probe error or temperature alarm, the instrument signals the event through acoustic signal and by closing the relay contact. By pressing the mute key, the buzzer is silenced.

 

A number of parameters are displayed alphanumerically to set up the instrument for each specific function. Computer Connectivity over RS485 and Remote monitoring(Optional).
Single Operation Quick Freeze Mode(Press QF Key for 2 sec), set system in quick freeze mode which is time based for that period new set point will be lower than running set point and system will try to achieve that set point, after time period over set point will be normal set point.

Main Features:

• 3 dotmatrix display to display all parameters
• Precise temperature Range : – 50.0ºC to + 50.0ºC and Resolution 0.1 C
• HP/LP , AUX faults for compressor protection.

Input & Output:

• 3 NTC probes for Room temerature, Coil temperature, Condensor Temperature.
• 1 RH sensor with 4 – 20mA input for humidification.
• Contactor outputs : Compressor, Condensor, evaperator, Relay output : Liquid SV,Alarm, light & humidifier.
• HP,LP, Compressor O/L, SPP, Pump O/L, Auxiliary Fault trip protection for Compressor and defrost.
• Auto/Manual reset for HP, LP and Compressor current sensing upto 20Amp.
• It also protect compressor by tripping it in underload & overload conditions.